Get Easy Test Results A simple way to test the shear torque of weld studs. Apply a straight pull of the WSTT wrench (no side load). When the wrench breaks-over and the weld stud is still attached then it passed. If the weld stud breaks off – then it failed.
Setting Adapter Item # 020572 The setting adapter is used for setting the torque of the WSTT with a torque analyzer. The Setting Adapter features a 3/8 square drive on one side. The other end features a blank end so you can weld the appropriate weld stud.
Item # Model 061461-25 Pin for End Fitting 2.5mm 061461-3 Pin for End Fitting 3mm 061461-4 Pin for End Fitting 4mm 061461-5 Pin for End Fitting 5mm 061461-6 Pin for End Fitting 6mm 061461-8 Pin for End Fitting 8mm 061461-10 Pin for End Fitting 10mm 061461-12 Pin for End Fitting 12mm
Get Easy Test Results A simple way to test the shear torque of weld studs. Apply a straight pull of the WSTT wrench (no side load). When the wrench breaks-over and the weld stud is still attached then it passed. If the weld stud breaks off – then it failed.
Mountz Torque Multipliers
Mountz Torque Multipliers
Break Over Torque Wrenches
Hand Torque Multiplier
Mountz Torque Analyzers
BLRTSX-RAU Brushless Rotary Torque & Angle Shaft Sensor with Mounting Base
Hand Torque Multiplier
Calibration Equipment
Insulated Torque Wrench
Mountz Torque Analyzers
Mountz Torque Wrenches
Electronic Torque Wrenches
Mountz Torque Analyzers
Break Over Torque Wrenches
Mountz Torque Analyzers
Dial Wrenches
Mountz Torque Analyzers
Break Over Torque Wrenches
Mountz Torque Analyzers
Mountz Torque Analyzers
Mountz Torque Analyzers
